hydraulic jack tension anchor

Hydraulic Jacks - DSI USA - dsiamerica.com

Multistrand Post-Tensioning System Hydraulic Jacks jack type 59 ... (0.5") 01 02 03 04 05 06 07 08 09 12 15 19 27 37 Mono 0.6 x HoZ 950 x x x ...

Post Tensioning Installation Equipment - Williams Form

T8Z-18 Hydraulic Torque Wrench: The hydraulic torque wrench is used for tensioning anchors in tight fitting locations where it would be difficult to use an hydraulic jack. The wrench is also recommended for use when setting the large diameter Spin-Lock anchors.

Polyester Resin Anchor Installation Equipment - Williams Form

T8Z-18 Hydraulic Torque Wrench: The hydraulic torque wrench is used for tensioning anchors in tight fitting locations where it would be difficult to use an hydraulic jack. The wrench is also recommended for use when setting the large diameter Spin-Lock anchors.

50 Ton Hydraulic Tension Anchors Single Prestress Jack

50 Ton Hydraulic Tension Anchors Single Prestress Jack , Find Complete Details about 50 Ton Hydraulic Tension Anchors Single Prestress Jack,Single Prestress Jack,Hydraulic Tension Jack,50 Ton Hydraulic Tension Jack from Car Jacks Supplier or Manufacturer-Liuzhou Lingqiao Prestressed Machinery Co., Ltd.

Hydraulic Strand Jacks | Strand Jack Systems | Enerpac

Hydraulic Strand Jacks The strand jack lifting technique originates from the concrete post tensioning principle. A strand jack can be considered a linear winch. In a strand jack, a bundle of steel cables or strands are guided through a hydraulic cylinder; above and below the cylinder are anchor systems with wedges that grip the strand bundle.

Stressing, Load Testing and Post Tension Equipment | Hydra

The jack frame typically bears against the steel plate while the hydraulic ram transfers a direct tension load to the application. When the pre-stress load is achieved, using Hydra Capsule’s digital pressurising equipment, the anchor nut and/or tendon wedges can be manually saeted to the pre-determined load, the jack is then released. The ...

SJ: 20 - 30T Post Tension/Stressing Jack | Power Team

Order Number Description Cylinder Capacity (tons) Stroke (mm.) Seater Type. Metric Tons at 700 bar. Weight (kg.) SJ2010: Post tension jack with spring seater, 12,7 mm strand.

Equipment - DSI USA

An open throat, twin ram jack for stressing 0.5 (12.7 mm) or 0.6 (15.2 mm) single strand is suitable for stressing at tendon ends or at intermediate tendon anchors. For tendon elongation greater than the stroke of the jack, the wedges are temporarily seated after partial stressing and the jack is recycled.

Lead Concrete Anchors Wholesale, Concrete Anchor …

.com offers 541 lead concrete anchors products. About 3% of these are anchors. A wide variety of lead concrete anchors options are available to you, such as concrete anchor, anchor bolt, and wall anchor.

Hydraulic Stressing Jacks - Hydraulic Pre-Post Tensioning

Manufacturer of Hydraulic Stressing Jacks - Hydraulic Pre-Post Tensioning Jack, Anchor Heads, Hydraulic Multi Stressing Jack With Hydraulic Locking and Hydraulic Single Strand Jack offered by Kanwar Engg Industries (R), New Delhi, Delhi.

the jack to the rod was to be pretension with a torque wrench set to 100 ft-lb which is equivalent to ca. 1200 lb of tension. The described test setup would allow the group to theoretically apply an upward force in the range of 0-40000 lb which well exceeds the calculated loads on a single anchor bolt in the preceding section.